Replacement trigger lever for garden hose spray nozzle
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
3D printed replacement trigger lever for a garden hose spray nozzle. Print in PETG, supports required.
- Ocena
- 5 / 5
- Polubienia
- 5
- Pobrania
- 35
- Wydruki
- 1
- Wyświetlenia
- 132
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
My garden hose spray nozzle trigger lever broke — a thin plastic part that takes a lot of mechanical stress every use. Instead of buying a new nozzle, I modeled and printed a replacement.
The lever pivots on the original metal bolt and works with the original orange locking clip (not printed). The geometry is designed to match the original part closely so no modifications to the nozzle body are needed.
Print settings (important — this part is load-bearing):
Material: PETG (recommended — good impact resistance and moisture tolerance for outdoor use)
Layer height: 0.2 mm
Perimeters/walls: 4 minimum
Top/bottom layers: 6
Infill: 30%
Supports: required (the pivot hole area needs support)
Do not print in PLA for outdoor/garden use — it degrades quickly under UV and moisture. PETG or ASA strongly preferred.
Printed successfully on a standard FDM printer. Should fit most similar spray nozzles with the same trigger pivot geometry, though exact fit depends on your specific nozzle model.
If you want to thank me, https://ko-fi.com/maxpi