Mini Cooper R53/R52/R50 Downtube Replacement Cover
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a cover to replace the downtubes on the sides of the center console/radio/toggle switches on an R53/R52/R50 Mini
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 41
- Wydruki
- 0
- Wyświetlenia
- 378
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Print setting recommendations:
PETG or better
.16 layer height
2+ walls
10% Gyroid infill
No supports required
Most important thing here is the filament type. Don't use PLA. This is going in your car, it's going to get hot in there. 2 walls and 10% infill is fine as this isn't a structural part, just a cover for the sides of your center console, but don't let your memes be dreams.
Installation:
Remove the downtubes (watch the first 1:30 of this) - Not my video btw
Using the same screws that held in the downpipes, attach your 3D printed covers. Be sure not to over-tighten
I had concerns initially regarding, "are the stock downtubes helping to support the center console?", and couldn't find a definitive answer other than, “doesn't seem like it”… I've had these covers installed in my car for almost 3 years and there is absolutely no sagging of the console. That being said, by using this print, you take full responsibility for your car.
If you have any questions or issues please let me know!