1 / 2
Fan Baffle for Ender 3 Mainboard Enclosure on Anet A8 Plus — zdjęcie 1
1 / 2

Fan Baffle for Ender 3 Mainboard Enclosure on Anet A8 Plus

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is a simple noise reducing fan baffle for the enclosure lid on my Ender 3 board to A8 Plus board enclosure.

Ocena
0 / 5
Polubienia
0
Pobrania
4
Wydruki
0
Wyświetlenia
24
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
GNU General Public License v3.0

Since I brought my garage printer, the Anet A8 Plus inside to do some maintenance, I decided the two 4010 fans I have in the electronics enclosure are just too noisy to bear, so I made this little fan baffle who's openings point to the rear.  It attaches using the same screws holding my fans in place.

I have a similar noise issue going on with my Sunlu T3 who's electronics enclosure I used as the base for my A8 Plus's enclosure, which shares the same lid design and dual 4010 fan design as my A8 Plus.  This duct adds 10mm's to the profile of the lid, and since my T3 is still using the stock short pads as feet, this model won't work directly with that machines configuration unless I put some taller feet on it.  I suppose I'll get to that eventually...

This is a niche part tailored to work with other niche parts I'm using on my machines, but I'm posting it anyways so that it may be used by others with machines having similar configurations.

The Ender 3 Mainboard Enclosure for the Anet A8 Plus project is here:

The Sunlu T3 to Creality Ender 3 Conversion project from which the above project was derived is here:  

Tagi