ZOHD Nano Talon EVO Flight Controller Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Mount for attaching a standard 30.5x30.5mm flight controller inside the ZOHD Nano Talon EVO.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 1
- Wydruki
- 0
- Wyświetlenia
- 39
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a simple printable mount that goes inside the fuselage of a ZOHD Nano Talon EVO frame. It is designed to mount a standard 30.5x30.5mm flight controller. I printed mine in PLA PRO and attached it to the frame with a bit of hot glue on the underside of the print. The design also has room for 3x small zipties for cable management. Use M3x8-12mm screws to attach the FC to the mount.
I've also included a small part for holding an ELRS receiver in place; however, I don't recommend using it. Instead, recommend mounting an antenna like in the second picture of this design from Thingiverse: https://www.thingiverse.com/thing:5024284