Lenovo ThinkCentre M720 Tiny 10" 1U Rack Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A simple snap in 10" 1U rack mount for the Lenovo ThinkCentre M720 Tiny.
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 42
- Wydruki
- 0
- Wyświetlenia
- 356
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution
A simple snap in 10" 1U rack mount for the Lenovo ThinkCentre M720 Tiny.
Printing
I have used dirt-cheap black PETG which is holding up fine. Try to avoid PLA as it probably won't hold up very well to the higher temperatures a homelab/rack may experience. I recommend PETG, ASA, ABS or some other plastic which holds up fine to temperature.
I printed with a 0.6mm nozzle on a Ender 3 v2 using default slicer settings, that worked fine and yielded a good-enough result. Any nozzle size ≤0.6mm should work fine too.
Fits on a 45° angle on a 220x220mm build plate such as the Ender 3
I printed with a 0.2mm layer height but I am sure this too can be tweaked quite a bit
No supports are needed
Print face down on the the bed
Uses about 44m or 135g of filament