HP EliteDesk 800 G6 Mini 10" 1U Rack Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A simple snap in 10" 1U rack mount for the HP EliteDesk 800 G6 Mini. Should be compatible with ProDesk G6 models as well
- Ocena
- 5 / 5
- Polubienia
- 22
- Pobrania
- 260
- Wydruki
- 0
- Wyświetlenia
- 1047
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution
A simple snap in 10" 1U rack mount for the HP EliteDesk 800 G6 Mini. Should be compatible with ProDesk G6 models as well.
Printing
I have used dirt-cheap black PETG which is holding up fine. Try to avoid PLA as it probably won't hold up very well to the higher temperatures a homelab/rack may experience. I recommend PETG, ASA, ABS or some other plastic which holds up fine to temperature.
I printed with a 0.6mm nozzle on a Ender 3 v2 using default slicer settings, that worked fine and yielded a good-enough result. Any nozzle size ≤0.6mm should work fine too.
Fits on a 45° angle on a 220x220mm build plate such as the Ender 3
I printed with a 0.2mm layer height but I am sure this too can be tweaked quite a bit
No supports are needed
Print face down on the the bed
Uses about 42m or 128g of filament
