Metalfish S5 Max - HDD Holder/Caddy (compatible with cooling fans)

Requires 2 screws to mount at the top.

MOUNTING - HOLDER: Either screw in with the screws that come with the fan, or use M3 heat inserts and M3 countersink screws (in this case I would recommend washers). Both will work.

MOUNTING - HDDs: HDDs can be mounted with M3 screws. Use countersink for better aesthetics. Not sure about the length, but 8mm should be more than enough. 

FANS: Can be used with a 92mm fan or a 120mm with a 120-95mm adapter. 15mm fan thickness recommended; 25mm would be pushing it and MAY NOT fit depending on your motherboard). Half of the fan will be blowing on the HDDs (5 degrees reduction in HDD temperature) and the other half to the CPU cooler (in case you have a tower cooler).

In case your 92mm fan is as bad as mine that blows air to the sides, you can print "92mm blower tube.stl" that will direct the air downwards. Simple solution, though I would install the 120mm fan on the left of the holder, like in the pictures because the temperature on the HDDs stays below 43 even without the fan and the 92mm can be repurposed to the front or back of the case.
To install the 120mm fan, you can either just screw in through the vent holes, or print my lightweight 120-92mm fan adapter (and you would still need to screw in through the vent holes, but the fan will actually be straight and aligned with the holes):

This HDD holder that I made, made my PC build super efficient and nice looking. I use 2 3.5" HDDs and 1 SSD. I mounted the HDDs on this holder and the SSD I mounted flat in the bottom right corner. 

My specs:
RTX 5060 8GB Palit Dual OC (3d printed white covers from their official website);
CPU: Xeon E5 2697v3;
Motheboard: Micro-ATX X99-XD4 by ADMEXE;
32GB RAM Atermiter 3200MHz;
Corsair PSU - ATX size.

Check out my collection for the Metalfish S5 Max accessories!
https://www.printables.com/@NikitaIgn/collections/3524100