Eschenbach 33213 Microscope 48mm Barlow Lens Adapter
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Adapter for the Eschenbach 33213 allowing standard 48mm Barlow lenses instead of their proprietary push-fit lens system.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 2
- Wydruki
- 0
- Wyświetlenia
- 33
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- GNU General Public License v3.0
This adapter was designed for the Eschenbach 33213 microscope, allowing standard 48mm Barlow lenses to be used in place of the original proprietary Eschenbach accessories.
The factory microscope uses a ribbed push-fit mount for Barlow lenses, limiting users to Eschenbach's own lens range. This adapter provides a simple alternative by accepting commonly available 48mm lenses.
The design consists of a cylindrical sleeve with an internal retaining lip that supports the lens. The adapter slides over the microscope turret and is supported by the three existing 4mm ring-light retaining screws, requiring no permanent modifications to the microscope.
Features
Uses standard 48mm Barlow lenses
No modifications required to the microscope
Simple one-piece print
Reversible installation
Compatible with existing ring-light mounting screws
Cost-effective alternative to proprietary accessories
How It Works
Insert the 48mm Barlow lens into the adapter.
The internal retaining lip prevents the lens from passing through.
Slide the adapter over the microscope turret.
The adapter rests on the three ring-light retaining screws for support.
Use the microscope as normal.
Notes
Designed specifically around the Eschenbach 33213 microscope.
Fit may vary slightly depending on printer calibration and lens manufacturer tolerances.
You may need to scale or lightly sand the model if your printer tends to produce tight fits.
Tested with standard 48mm Barlow lenses.
Print Settings
Polycarbonate is recommended if you will be using a hot air gun... it can stand around twice the temperature of PETG, but do not heat it directly with the hot air or it will melt.
Polymaker PolyMax PC:
Layer Height: 0.20 mm
Wall Count: 3–4
Infill: 15–20%
Material: PC
Supports: Not required
Brim: 10mm
Fan: Disabled
Print with the large opening facing upward for the cleanest internal lip.
PETG:
Layer Height: 0.20 mm
Wall Count: 3–4
Infill: 15–20%
Material: PETG
Supports: Not required
Brim: Optional
Print with the large opening facing upward for the cleanest internal lip.
Assembly
No assembly required beyond inserting the lens and mounting the adapter onto the microscope.
Disclaimer
This is an unofficial accessory and is not affiliated with or endorsed by Eschenbach.