Versatile rugged cup holder for 8020 40-series horizontal rail
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a sturdy and versatile cup holder designed to be fastened to horizontal 8020 40-series rails.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 13
- Wydruki
- 0
- Wyświetlenia
- 128
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial
This cup holder can hold a variety of different cups, cans, and bottles, with or without a handle. It is designed to be fastened to a horizontal 8020 extruded aluminum rail with a single threaded star knob, a washer, and a hammerhead T-bolt. A small step on the back surface prevents the holder from rotating on the rail.
The cup holder is attached to a horizontal 40-series (40mm) or 15-series (1.5 inch) rail with an M8 threaded star knob, M8 washer, and 40-series hammerhead T-bolt with an M8 x 19mm stud. It could also be mounted on 25-series (25mm) or 10-series (1 inch) rails with M6 hardware.
Three heights are available. The tallest one (6 inch stem above the ring) can be attached to a rail near the ceiling and still allow easy access for a tall bottle. The shorter ones can be used in areas where there is no height restriction. The ID of the circular opening is 3.3 inches. The top of the ring is about 3.3 inches above the foot. There is a gap in the ring for a handle.
I printed the 6-inch version with PETG, 0.15mm layers, with supports everywhere, 30% fill, and a brim. I positioned it flat on its back, rotated about 35 degrees to fit on the plate. On my Prusa MK3S+, it took about 30 hours and 240g of filament.
The result is very durable and stiff, and should hold up well even with rough use.