1 / 2
PIP Clog Sleigh Bell + Hi-hats charms — zdjęcie 1
1 / 2

PIP Clog Sleigh Bell + Hi-hats charms

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Are you gonna just... walk or are you gonna make some noise?

Ocena
0 / 5
Polubienia
16
Pobrania
19
Wydruki
0
Wyświetlenia
126
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

I ve always loved diy instruments! these clogs sound soooooooo good!

Print and placement Instructions

  • Print with 0,4 nozzle, 0.2mm layer height, 4 perimeters

  • Use the specific files for PETG or PLA (the tolerances are adjusted differently for each material).

  • Using the provided .3mf files is highly recommended!

  • Bells Once printed, place the pin in the hole with help of pliers.

  • Snap the inside ball to break it. If the ball snaps before placing, be carefull not to lose it 

  • Hi-Hats. Let them cool and separate the two cymbals.Use a blade if needed (normally it should seaparate easily).  Push the Pin all the way down until it snaps. Use a blade if needed (normally it should seaparate easily) 

  • Note for Silk PLA: Because Silk PLA can behave differently and weld more easily, I have included the .3mf files with settings that successfully worked for me.

  • Printing with PETG is highly recommended. 

Have fun and keep the beat going!

Tagi