Reducer Bushing to fit AP Bobinquick Junior and Kaiser Film Loader for Kodak 35mm film U-Core (2inch/52mm) and the 400ft to 100ft Respooler
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a reducer bushing which allow film respooled to fit the AP Bobinquick Junior and Kaiser Film Loader
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 15
- Wydruki
- 0
- Wyświetlenia
- 113
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Photo & Video
- Licencja
- Open Community License v1.1 + General Attribution v1
This is to fit the:
Kodak 35 mm U-Core 2 inch / 52mm film core/spool
and
400ft to 100ft Bulk Film Respooler by @MaslovyRohlik
originally the [Thingiverse] 400ft to 100ft Bulk Film Respooler by @broken_perfectionist

This is a handy device to reducing a 200ft or 400ft roll of 35mm film down to 100ft but the spool it uses will not fit most film loaders.
I have the AP Bobinquick Junior which is apparently the same product as the Kaiser Film Loader.
I created a reducer bushing to make the spool that comes with the respooler fit the AP Bobinquick


Details
Fits snug enough inside the original spool that its not loose.
Protrudes slightly on both sides so there is not much play between the spool and the bulk loader.
Loose enough that it spins freely and holds the spool away from the sides of the bulk loader.
The settings I used on the Prusa Core One +
Prusament PLA
Printed using the attached step file
0.15 Structural Preset
0.6mm Nozzle
Cubic 30% infill
Variable layer height (most layers will be 0.3mm)
25 min print time
Pictured inside an AP Bobinquick Junior:
