1 / 3
Reducer Bushing to fit AP Bobinquick Junior and Kaiser Film Loader for Kodak 35mm film U-Core (2inch/52mm)  and the 400ft to 100ft Respooler — image 1
1 / 3

Reducer Bushing to fit AP Bobinquick Junior and Kaiser Film Loader for Kodak 35mm film U-Core (2inch/52mm) and the 400ft to 100ft Respooler

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Estimated printing price per file

€0.46 – €0.56 net (excluding VAT)

For file: Bobinq_Reducer_Bushing_0.4n_0.15mm_PLA_COREONE_23m.bgcode

This is an estimate for one file. You’ll confirm the exact price before ordering.

File and estimate settings

File used for this estimate

Average indicative estimate: €0.51 excluding VAT (range midpoint).

Weight reported by the author
9 g
Print time reported by the author
23.4 min
Source material
PLA
Estimate material
PLA
Estimate printer
Bambu Lab P1S - 0.4 nozzle
Estimate process
0.20mm Standard

Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.

Saved on this device.

This is a reducer bushing which allow film respooled to fit the AP Bobinquick Junior and Kaiser Film Loader

Rating
0 / 5
Likes
2
Downloads
15
Makes
0
Views
113
Reviews
0

Updated at source:

Model information

License
Open Community License v1.1 + General Attribution v1

This is to fit the:

Kodak 35 mm U-Core 2 inch / 52mm film core/spool

and

400ft to 100ft Bulk Film Respooler by @MaslovyRohlik

originally the [Thingiverse] 400ft to 100ft Bulk Film Respooler by @broken_perfectionist

  

 

 

  

 

    

This is a handy device to reducing a 200ft or 400ft roll of 35mm film down to 100ft but the spool it uses will not fit most film loaders. 

I have the AP Bobinquick Junior which is apparently the same product as the Kaiser Film Loader.

I created a reducer bushing to make the spool that comes with the respooler fit the AP Bobinquick

Details

  • Fits snug enough inside the original spool that its not loose.

  • Protrudes slightly on both sides so there is not much play between the spool and the bulk loader.

  • Loose enough that it spins freely and holds the spool away from the sides of the bulk loader.

The settings I used on the Prusa Core One +

  • Prusament PLA

  • Printed using the attached step file

  • 0.15 Structural Preset

  • 0.6mm Nozzle

  • Cubic 30% infill

  • Variable layer height (most layers will be 0.3mm)

  • 25 min print time

Pictured inside an AP Bobinquick Junior:

Tags