1 / 1
IKEA ALTARLIDEN 80 cm Rail Extension – Fit a Real 80 cm Wardrobe — zdjęcie 1

IKEA ALTARLIDEN 80 cm Rail Extension – Fit a Real 80 cm Wardrobe

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Makes the IKEA ALTARLIDEN "80 cm" rail (actually 76.4 cm) fit a true 80 cm wardrobe — with the original brackets.

Ocena
0 / 5
Polubienia
0
Pobrania
8
Wydruki
0
Wyświetlenia
48
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Bedroom
Licencja
Creative Commons — Attribution — Noncommercial

The problem

The ALTARLIDEN clothes rail (IKEA article 205.966.93, "80 cm") is designed around IKEA's cabinet system: the "80 cm" refers to the outer frame width, so the rail itself only spans an inner width of about 76.4 cm. If your wardrobe actually measures 80 cm on the inside, the rail is roughly 3.5–4 cm too short and simply won't reach the second bracket.

The solution

A printed extension piece with a two-stage profile:

  • A 20 mm spigot that slides snugly into the hollow end of the ALTARLIDEN rail

  • A 40 mm body that continues the rail's original outer profile (approx. 15 × 21 mm oval), so it seats in the unmodified original IKEA wall brackets — no drilling, no bracket hacks

The rail keeps its clean look; once installed, the white PLA blends in with the white rail and you barely notice the joint.

Printing

  • Material: PLA works fine (tested with Prusament PLA); PETG if your wardrobe gets warm

  • Layer height: 0.2 mm

  • Infill: 15 %

  • Perimeters: 2 walls

  • Supports: yes — print it lying down (long axis horizontal) for better strength and stability, which requires supports for the profile overhang and the inner cavity

  • Tested on a Prusa CORE One, ~6 cm³ of material per piece, prints in well in 25min

Installation

  1. Mount the IKEA brackets at your actual wardrobe width, following the original instructions.

  2. Push the spigot end of the extension into the open end of the rail until it bottoms out on the shoulder.

  3. Seat the rail in the brackets as usual.

The fit of the spigot is designed to be snug. If your printer runs tight, a light pass with sandpaper on the spigot does the trick; if it's loose, a drop of superglue secures it permanently.

Notes

  • The extension carries part of the load at the bracket, so stay within IKEA's rated load for the rail — for a normal row of shirts and jackets this is a non-issue.

  • Remixes for other inner widths: the model is easy to stretch along its length — feel free to remix, and let me know in the comments if you'd like other sizes.

Tagi