1 / 1
Bike brake rotor external Center Lock / 16-tooth 44mm bottom bracket tool - 40nM tested (PT 69.3/69.4/19.2 equivalent) — zdjęcie 1

Bike brake rotor external Center Lock / 16-tooth 44mm bottom bracket tool - 40nM tested (PT 69.3/69.4/19.2 equivalent)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is a remix of @rsilvers bottom bracket tool without tapered walls for easier printing and higher strength.

Ocena
0 / 5
Polubienia
3
Pobrania
42
Wydruki
0
Wyświetlenia
101
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Tools
Licencja
Creative Commons — Attribution

This tool allows the use of a 1/2" drive (torque) wrench to mount and remove bicycle 16-tooth 44mm bottom brackets and disk brake rotor external Center Lock rings.

I found @rsilvers original tapered design of this tool nice but difficult to print with very high wall-count and infill without the overhangs curling up. It was important to me that the tool allow me to mount my bike's brake rotors with the correct amount of torque so I needed to max out the walls and infill. To achieve this I removed the 45 degree taper at the wrench side, as well as the fillet around the opening of the tool from the original model.

I printed this in bambu PETG-CF (only because that's what I had at hand, regular PETG or other filaments are probably just as good if not better, but I haven't tested them). The below settings uses about 60g of filament if you print the whole 20mm model*. As printed the tool fit snuggly.

  • 0.24mm layer height

  • 0.4 nozzle (hardened)

  • 7 walls

  • 100% infill (crosshatch)

  • 1.0 extrusion multiplier

I have used the tool twice with a torque wrench at 40nM to fit bicycle disk brakes. See below pictures of the effect this has had on the tool. Slight deformation, don't expect it to last forever, but plenty of life left in it. 

*The cup need only be deep enough to clear the spindle that sticks out through the middle of the lock ring. I have uploaded a 20mm deep cup model which I have tested, and a 30mm deep model should you need it. Save yourself time and money by only printing the cup as deep as you need. If you only need 10mm or so of clearance, just trim the model in your slicer, or even easier, stop the print when it's tall enough. Note I have only tested the cup at 20mm depth.

Tagi