Remote ID Module Holder for DJI Mavic Air 2 (& 2S) Holyton & Holystone unit
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Clips on to battery, holds remote ID module to drone. This unit: https://www.amazon.com/dp/B0FPF1VTKK/ref=twister_B0FV76
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 14
- Wydruki
- 0
- Wyświetlenia
- 62
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial
Clips on to the battery pack, holds remote ID module to drone. This unit: https://www.amazon.com/dp/B0FPF1VTKK/ref=twister_B0FV76J1MQ
Should be a snug fit, mine has the velcro pad on back, so if yours is too loose, add the velcro pad to unit to snug up the fit. Hole on one side to push out unit, hole on other side for controls and charging port. May make changing the battery a bit harder, but I believe in you... you can do it!
If you have the Holystone unit or the clone Holyton one but are using a different drone, I also have the stl here for just the case, and you can modify or remix it to fit your specific use case or mounting solution.
I used tree supports, and a bit of patience removing them from the inside area. Maybe there was a better way to orient it in the slicer, try it out!