Sun Sail Rope Cleat / Small Horn Cleat
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
3D printed horn cleat for tying off lightweight rope, cord, sun sails, shade sails, tarps, and patio covers.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 23
- Wydruki
- 0
- Wyświetlenia
- 76
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Standard Digital File License
A small 3D printed horn cleat for tying off lightweight rope, cord, and paracord.
I designed this to keep sun sails / shade sails tied up around the yard, but it can also be used for light-duty rope management, shop organization, camping setups, patio covers, tarps, nautical-themed projects, and general utility use.
The shape is based on a simple two-horn cleat, so rope can be wrapped in a figure-eight pattern and tied off cleanly without needing a knot every time.
Recommended materials:
PETG, ASA, ABS, or nylon are recommended for outdoor use. PLA may be fine for indoor or decorative use, but it is not ideal for sun, heat, or long-term outdoor tension.
Print recommendations:
Use extra walls and higher infill if the cleat will see real tension. Mount securely with appropriate screws and make sure the print orientation, material, and hardware match your use case.
Important note:
This is a 3D printed utility cleat, not certified marine, climbing, towing, or life-safety hardware. Shade sails and tarps can see serious wind loads, so do not use this as the only critical anchor point in high wind or storm conditions. Test your print and mounting method before relying on it.