Flashlight Mounting Clip
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This print allows a flashlight to be clamped to a baseball cap.
- Ocena
- 0 / 5
- Polubienia
- 12
- Pobrania
- 26
- Wydruki
- 0
- Wyświetlenia
- 136
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
I designed this adaptor to link a binder clip to a flashlight, allowing me to clamp said flashlight to a baseball cap. It is symmetrical, so either side works, and it can obviously clamp to other things. This was designed to fit a 2” binder clip and a 1” diameter flashlight.
Bill of Materials:
One 1” flashlight and one 2” binder clip, 12g of filament
Printing:
Walls, Top/Bottom Layers: 4, 4/4
Infill – doesn’t matter
Walls: 0.4-0.5mm
Supports: None
Orientation: Place one of the two flat faces down
Material: 12g, Any material but TPU should work
Assembly:
Take off one of the wire handles from the binder clip. Slide this side of the binder clip into the adaptor, and press the flashlight into the C-socket until it clicks. It is an intentionally tight fit. I found it good to keep the other wire handle on to facilitate removal/adjustment.