DryFlow Filament Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Dry, smooth, reliable filament feeding with a compact holder and integrated desiccant chamber.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 1
- Wydruki
- 0
- Wyświetlenia
- 21
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial
I printed this because I needed something to hold my filament, reduce humidity, and feed the filament at the same time. So, I came up with this. It was designed to sit on the same table next to the printer. I only tested it with 1kg spools, but there is about 20-25mm of clearance above the spool until it hits the lid, so you could probably put one in there. I also added magnet inserts on the back, and happy to accommodate for anyone with different magnets on hand. I also added a gromet insert, a ¼", 6.35mm gromet, but I didn't end up using it because the tether was smoother without it. I also designed this to have a 1mm thick by about 2mm TPU gasket, but I think its airtight enough. If you want to do that, also added that part. comment any recommendations or opinions.