FMS 800mm Beaver Wing Strut Attachment Base Replacement (Prototype)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Replacement wing strut attachment base for the FMS 800mm Beaver. Prototype design—feedback welcomed!
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 6
- Wydruki
- 0
- Wyświetlenia
- 22
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a replacement wing strut attachment base for the FMS 800mm Beaver. The original plastic mounting base on the fuselage can become damaged in a hard landing or other mishap, making it difficult or impossible to securely attach the wing strut. It has been built based on the measurements of another user and myself as it sits in the fuse.
This replacement is designed to fit in place of the original part and restore the wing strut mounting point.
V1 is about right. The forward hole is not large enough for a factory strut. I'm working on V1.5 now and will see how it fits. These should fit either right or left. I'm making this without being able to test fit it.
V1.5 accepts a strut base. It should work for either left or right. I will not be a perfect fit; it will hopefully be a functional fit.
Please note: This design is currently a work in progress and has not yet been extensively tested. Fit and durability may vary, and revisions are likely as additional feedback is received. If you print and install this part, I'd appreciate hearing how it fits and performs so future versions can be improved.
Print Settings
Material: PETG recommended (PLA may work but is less impact resistant.)
Layer Height: 0.20 mm
Perimeters: 4–5
Infill: 30–50% Gyroid or Cubic
Supports: As needed, depending on print orientation.
Brim: Optional if bed adhesion is a concern.
Weight: about .5 Gm material (PLA will probably work just fine)
Tiime: about 3 minutes
Print Orientation
Print the part with the flat mounting surface on the build plate unless your testing indicates a stronger orientation. Strength around the strut attachment point is more important than appearance.
Notes
Designed for the FMS 800mm Beaver.
This is an aftermarket replacement and is not an OEM part.
Feedback, fit reports, and suggested improvements are welcome.
Related FMS 800mm Beaver Parts