FMS 800mm Beaver Wing Strut Attachment Mount (Wing) - Prototype
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Replacement wing strut mount for the FMS 800mm Beaver wing. Prototype design; PETG recommended.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 3
- Wydruki
- 0
- Wyświetlenia
- 19
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a prototype replacement wing strut attachment mount for the FMS 800mm Beaver. It is intended to replace the plastic fitting installed in the wing where the wing strut attaches.
This design is speculative and has not yet been flight tested. It was modeled from available measurements and should be a drop-in replacement, although slight dimensional differences may exist depending on the original factory part. Feedback on fit and durability is greatly appreciated.
Print Recommendations
Material: PETG strongly recommended. PLA may fit and function, but its brittleness makes it more susceptible to breaking in service.
Print Orientation: Print at approximately 45° with supports. Printing flat on the build plate leaves the attachment flanges weak and they are likely to snap off.
Layer Height: 0.20 mm
Perimeters: 2
Infill: 100%
The part uses approximately 1 gram of filament and prints in about 5 minutes, making it quick and inexpensive to replace if needed.
As always, install at your own discretion and inspect the part regularly until the design has been validated through additional testing.
Related FMS 800mm Beaver Parts