HP EliteDesk 800 G2 Mini — RJ45 NIC Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Replaces the DisplayPort daughterboard on the back of an HP EliteDesk 800 G2 Mini with a second gigabit ethernet port.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 19
- Wydruki
- 0
- Wyświetlenia
- 166
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Art & Designs
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Replaces the DisplayPort daughterboard on the back of an HP EliteDesk 800 G2 Mini with a second gigabit ethernet port. The mount clicks into the daughterboard opening from the outside and holds the RJ45 port in place, so the M.2 NIC card's cable plugs straight into the back of it. Clean factory look, no hacksaw, no metal shavings — the whole mod stays reversible. PRINT SETTINGS - Material: PETG recommended (sits near the CPU/heat area, PLA may soften over time) - Supports: none needed - Infill: 15-20% - Layer height: 0.2 mm HARDWARE NEEDED - 2x M3x10 screws (mount) - Screws from the Wi-Fi / daughterboard (reused to secure the NIC card) - Panel locking screw (reused) ASSEMBLY 1. Remove the Wi-Fi card from the M.2 A+E slot (or leave empty if your unit has none). 2. Lift the fan out, remove the CPU heatsink (3 Torx screws). 3. Undo the two daughterboard screws and lift the DisplayPort board out — keep its screws, they secure the NIC card. 4. Slot the M.2 A+E NIC card into the slot, retaining screw in. 5. Unscrew the black panel locking screw, click the printed mount into the rear opening from the outside. 6. Plug the NIC cable's two push-on connectors into the back of the RJ45 port, screw the mount down, put the panel screw back. 7. Reapply thermal paste, refit heatsink and fan, boot and check the NIC shows up in BIOS/dmesg. Full step-by-step build guide with photos on my blog