Grove SPDT Relay 30A (SLA-05VDC-SL-C) Mount for Voron Switchwire
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Custom mount for the Seeed Studio Grove SPDT Relay 30A (SLA-05VDC-SL-C), designed for the Voron Switchwire / Enderwire
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 1
- Wydruki
- 0
- Wyświetlenia
- 33
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Voron Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
Description
Custom mount for the Seeed Studio Grove SPDT Relay 30A (SLA-05VDC-SL-C), designed specifically for the Voron Switchwire / Ender 3 V2 conversion.
I designed this mount to provide a clean and secure way to install the Grove 30A relay inside the printer. In my setup, the relay is used to switch the mains power going to the 24V PSU, while the Raspberry Pi remains powered by a separate 5V Mean Well PSU.
The mount is designed specifically around the dimensions of the Seeed Studio Grove SPDT Relay 30A and keeps the relay securely positioned while leaving the screw terminals and Grove connector easily accessible.
Instructions
01. Unplug the printer from the mains and make sure the power supply is completely disconnected before working on the electrical system.
02. Install the mount in the desired location on the printer frame using the appropriate fasteners for your setup.
03. Install the Seeed Studio Grove SPDT Relay 30A (SLA-05VDC-SL-C) into the mount. Make sure the relay is fully seated and securely held by the printed part.
04. The relay is intended to switch the 230V AC mains input of the 24V power supply. Do not switch the 24V output of the PSU with the relay.
05. For the mains wiring, switch the live/line (L) conductor through the relay. Connect the incoming live wire to COM and the live wire going to the 24V PSU to NO.
06. Leave NC unused. Using NO means that the relay is normally open. If the Raspberry Pi or the relay loses power, the 24V PSU remains switched off.
07. Tighten the screw terminals securely, but do not overtighten them. Make sure no bare conductor is exposed outside the terminal and that the wire cannot be pulled out.
08. Connect the Grove control cable to the Raspberry Pi. In my setup:
VCC → 5V
GND → GND
SIG → GPIO17
NC → not connected
The relay module is powered from the same separate 5V Mean Well PSU that powers the Raspberry Pi.
09. Configure your preferred software to control the GPIO and therefore the relay. This can be used to turn the printer's 24V system on and off remotely while keeping the Raspberry Pi powered.
WARNING — HIGH VOLTAGE
This mount is intended for use with a relay capable of switching mains voltage.
Working with 110/230V AC can cause serious injury, electric shock, fire or death. Only perform mains wiring if you understand the risks and are competent to do so.
Always disconnect the printer from the mains before working on the wiring. Use appropriately rated wires. The protective earth (PE) conductor must never be switched by the relay.
Follow the electrical regulations applicable in your country.