Ender 3 v2 motherboard cover with LED
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a remix of a good design, but I have added a diode (3 mm, red, 2V, 20 mA) with 510 ohm resistor powered by the…
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 15
- Wydruki
- 0
- Wyświetlenia
- 570
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution
This is a remix of a good design, but I have added a diode (3 mm, red, 2V, 20 mA) with 510 ohm resistor powered by the same converter as the fan (12V) and the LED is in the eye of Ender dragon which I have added to the front face of this cover. I think this is a nice touch and I can see when the fan is running, as they are now so silent that I can't hear them (PSU and MB with 80 mm silent fans max 15 db).
I have also added some cable management pins inside and several pins for mini converters.
I used mini 360 converters and only two (one for MB fan with diode, and another one for hot end fan with LED strip), but there is a plenty of space for 3-4 converters.
Unfortunately, the version I installed was the initial one, so I had to drill a little to make a diode hole wider at surface and also driller a canal for diode wires. However, in this posted version that's all included. I hope you will like it.
Category: 3D Printers