Snap-Fit Case for 400W 15A DC-DC Step-Up Boost Converter (No Screws)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Snap-fit case for 400W 15A Step-Up boost converter (8.5-50V to 10-60V). Screwless & prints without supports.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 21
- Wydruki
- 0
- Wyświetlenia
- 85
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Standard Digital File License
Snap-Fit Case for 400W 15A DC-DC Step-Up Boost Module
Custom, screwless snap-fit protective enclosure designed for the popular 400W 15A DC-DC Step-Up / Boost Converter Module (Input: 8.5–50V, Output: 10–60V).
Snap-Fit Clips: 4 integrated retaining clips along the side walls hold the PCB firmly in place without any screws.
Solder Joint Clearance: A 1.50 mm raised internal perimeter ledge keeps bottom solder pins elevated and protected.
Clean Look: Terminal cutouts for IN / OUT are raised by 1.60 mm to completely hide the raw PCB edges from the outside.
Support-Free: Fully optimized for FDM printing—prints directly on the build plate with zero supports required.
Recommended Print Settings
Material: PETG or PLA (PETG recommended for higher heat loads)
Infill: 20%
Wall Perimeters: 3
Layer Height: 0.20 mm
Supports: None
Note: The cover thumbnail image was created with the assistance of AI.