Cole and Mason Oldbury Salt & Pepper Mill Repair Part
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This part can replace the plastic part mounted in the cap of Cole & Mason Oldbury Grinders which can break over time.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 4
- Wydruki
- 0
- Wyświetlenia
- 31
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
The Cole and Mason Oldbury Grinders have a weak plastic part on the cap. The tabs can break and the central column holding the mounting screw can crack, making for a loose cap. I tried to buy a replacement, but they don’t sell them, nor would they provide one under warranty, so I designed a 3D printable replacement. I’ve tried to improve the design a bit so it won’t fail so easily, hopefully it works for you. I printed this on an old MakerFarm Prusa i3V printer, so any modern printer should handle it.
My recommended settings are standard PLA with an 0.2mm layer height and 30% infill. While you can try and print this sitting vertically on the bed, I printed mine at a 45 degree angle to improve strength at the tabs. If you do print at 45 degrees, you may need to paint on some support under the mounting screw column to give the part a little extra support as it starts printing. Other than that, I let the slicer determine the rest of the supports. Print files provided in both 3mf and STL.
The old plastic part is mounted to the cap by one Philips head screw in the center of the plastic part. Simply remove the old screw, pull out the old plastic part and install your new printed part and secure with the original screw. Good luck and hope this gives new life to your old grinder.