Fiat Spider 124 Front Sway Bare Bushings
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Inner bushing fits 1972+ models, outer bushing fits 1968-1985
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 2
- Wydruki
- 0
- Wyświetlenia
- 46
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Open Community License v1.1 + GAtt v1 + RnD v1
These are cost effective bushings for old 124 spiders. New rubber costs ~$4/ea, IDK if anyone makes poly bushings for the sway bar. These cost <$1/ea for me using Siraya Tech 85A TPU.
The inner bushings will fit 1972-1985, the outers will fit anything except 1985.5 models. EDIT: Looks like the outer bushings should work as the inner bushings on '68-'71 models, but I haven't tested it.
A lot of folks are understandably skeptical of using 3D printed suspension bushings. Check out Garage 54 on Youtube and saintchief_ on Instagram for some people who have done some testing/long term running of TPU bushings.
Instructions:
Drill the crimped over part of the sway bar mount out - I used a 1/2" drill bit for this. Don't go to deep or you'll chowder out the mounting holes too much.
Pull off the rubber bushings
Clean off the bar - this will make it easier to get the new bushings on.
Lube up the inside of the bushing with silicone brake grease - don't want it squeaking. The ribbing on the inside will help hold more grease for longer.
Put the bushings on the bar first (this is kinda a pain), then put the mount on the bushings - I don't think you need to worry about crimping the mounting holes again, just use some blue loctite on the bolts when you put them on the car.
Notes:
TPU 85A or lower hardness recommended (new rubber is ~72A).
USE 100% INFILL
95A might work, but it's a pain to push on the bar past the bends
Whatever silicone grease you have should work, you can buy it as caliper grease from auto parts stores