Fiat Spider 124 Front Sway Bare Bushings
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Inner bushing fits 1972+ models, outer bushing fits 1968-1985
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 2
- Makes
- 0
- Views
- 46
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Automotive
- License
- Open Community License v1.1 + GAtt v1 + RnD v1
These are cost effective bushings for old 124 spiders. New rubber costs ~$4/ea, IDK if anyone makes poly bushings for the sway bar. These cost <$1/ea for me using Siraya Tech 85A TPU.
The inner bushings will fit 1972-1985, the outers will fit anything except 1985.5 models. EDIT: Looks like the outer bushings should work as the inner bushings on '68-'71 models, but I haven't tested it.
A lot of folks are understandably skeptical of using 3D printed suspension bushings. Check out Garage 54 on Youtube and saintchief_ on Instagram for some people who have done some testing/long term running of TPU bushings.
Instructions:
Drill the crimped over part of the sway bar mount out - I used a 1/2" drill bit for this. Don't go to deep or you'll chowder out the mounting holes too much.
Pull off the rubber bushings
Clean off the bar - this will make it easier to get the new bushings on.
Lube up the inside of the bushing with silicone brake grease - don't want it squeaking. The ribbing on the inside will help hold more grease for longer.
Put the bushings on the bar first (this is kinda a pain), then put the mount on the bushings - I don't think you need to worry about crimping the mounting holes again, just use some blue loctite on the bolts when you put them on the car.
Notes:
TPU 85A or lower hardness recommended (new rubber is ~72A).
USE 100% INFILL
95A might work, but it's a pain to push on the bar past the bends
Whatever silicone grease you have should work, you can buy it as caliper grease from auto parts stores