Shimano TL-PD33 - Alternative Service Tool Solution for PD-M324 & PD-M505 SPD Clipless Pedals

Important Disclaimer: This is NOT INTENDED TO PERMANENTLY REPLACE A PROPER METAL TOOL, however, it works under reasonable loads and is dramatically cheaper to print when compared to purchasing the suppliers specialty tool. Your mileage will vary but it works well with engineering filaments and when temps are dialed in for proper layer adhesion.

Inspired by Dan Fein's great idea to swerve the tool that's more expensive than the pedals themselves! Sadly I was only able to get that model to work after trimming 3mm's off the end as the chamfer relief on my sockets kept them from engaging with the nut. Sockets without a relief would work but I did not have any.

This remix shortens the engaging end so that a greater variety of sockets can be used. Additionally, there are single and dual wall variants (for .4mm nozzles). The dual wall is similar to the original but requires a very thin wall socket to be inserted. The single wall is less robust but enables standard socket use. 

Printed in Prusament Polycarbonate Carbon Fiber, no supports. Part takes some impression damage but works well. PETG also works but is less robust and more of a single use item.