Hex Laptop Stand with Plugs for Customisation - Prebuild models for specific laptops included

A vertical desk stand that holds a closed laptop on its long edge, freeing the ports on both side edges - dock on USB-C at one end and Ethernet at the other. The honeycomb is not just decoration: every hexagon in the walls and the base takes the same flanged press-fit plug, so you print a handful of plugs in an accent colour and click them in wherever you fancy. No AMS or CFS needed, no purge tower, and you can rearrange the pattern any time.

FOUR SIZES - internal slot width is engraved in the slot floor. Measure your closed laptop at its thickest point and pick the nearest size up:

21.7 mm - Lenovo ThinkPad E14 (sized from Lenovo PSREF; fits both bottom-cover variants and most 20-21 mm laptops)

19.0 mm - Generic 14 inch (fits most common 14 inch business laptops, 16-19 mm thick)

16.7 mm - MacBook Pro 14 inch (2021-2026 chassis, 15.5 mm)

12.7 mm - MacBook Air 13 and 15 inch (11.3-11.5 mm)

INCLUDED FILES: the four stands (STL plus STEP for easy remixing), the accent plug, a one-hex fit coupon, and a strip of three test plugs at 0.10 / 0.15 / 0.20 mm clearance. Print the coupon and test strip first (a few grams), find which plug fits snug on your printer, then batch that clearance.

PRINT SETTINGS: PETG recommended - a laptop is a sustained load and PLA can creep over months. 0.4 nozzle, 0.2 mm layers, 2 walls, 15% infill, no supports anywhere. Print everything flat as oriented, plugs flange down. Shown in black PETG with red plugs.

The base is 168 x 120 mm with a chamfered slot entry so the laptop drops in without scratching, and four recesses underneath for 12 mm adhesive rubber feet (recommended).

Renders shown for now - photos of the first prints are coming shortly.