Pushbutton housing
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Housing / Enclosure for PBS-18B Push Button
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 3
- Wydruki
- 0
- Wyświetlenia
- 26
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
This is a housing for a PBS-18B momentary push button (PCB-mount, 1-pole ON/OFF). It's a simple two-part design:
Base – has a hole for routing the button's cable through, and the PBS-18B is soldered/wired and then pressed (seated) into the base.
Cap – a round disc that gets glued on top of the button with a small drop of glue. This cap becomes the actual pressing surface — it covers the button and transfers the press down onto it.
Once assembled, you get a clean, closed housing with no exposed switch — just press the round cap to activate the button. Useful for enclosing a bare PCB push button in a neat, finished-looking case for panels, boxes, or DIY projects.
Print notes:
Designed for the PBS-18B 1-pole push button
Cable routed through the base
Cap is glued on after the button is seated
The base opening is a tight press-fit, so the button stays firmly in place