Lenovo P360 Ultra vented bottom panel
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A replacement vented bottom panel for the Lenovo ThinkStation P360 Ultra
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 4
- Wydruki
- 0
- Wyświetlenia
- 49
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Share Alike
I can't guarantee accuracy as I no longer own this PC to make changes and to test them. This was my first attempt.
It's a very snug fit. One of the tabs did snap off during installation so I think they are either slightly too long or off by .5mm. They're also very thin which of course means they are weak.
How to get the panel off (images for steps will be last shown):
Take the front panel off by unscrewing the screws circled in red. Then you can unclip it circled in green.
Here we have to drill out the 3 rivets circled red. I used a 5mm bit. Once this is done you can unscrew it from inside the case also circled red. We'll use the two screws again for the new panel.
That's it. Now you can pull the panel out and install the new one.
I used M3x4x5mm inserts
Printed with PETG.
The original bottom panel restricts airflow. This version features an open ventilation pattern to improve airflow for the CPU and GPU. I didn't like the idea of printing a whole case like another model seen on here so I set out to make just a bottom panel. Feel free remix and improve on this.
Made in SketchUp and have included the .skp