5020 Bed Fan for Trident
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
For helping those chamber temps without setting the house on fire
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 4
- Wydruki
- 0
- Wyświetlenia
- 58
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Voron Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
I wanted a 5020 bed fan to help distribute chamber temps and this is what I came up with.
It uses. 5020 blower like this one from AE
I think most others should work but I've not tried them. The design includes wiring channels for the fan wire and also to route other wires to the front of the bed frame. I did this because I have status LEDs mounted under the bed on the front of the front extrusion.
Remove the half of the fan casing with nothing attached (no wires, motor etc) as the print replaces this half.
Mounting is via 2 M3x8 bolts and roll-in or t-nuts. Optionally you may want to use M3 bolts to hold the fan in but I found a friction fit was sufficient.
Recommend ABS or ASA or better. Supports needed for the underside

