1 / 2
Panasonic / Matsushita JU-475-4 5.25" floppy drive: replacement latch frame and rear shaft bushing — zdjęcie 1
1 / 2

Panasonic / Matsushita JU-475-4 5.25" floppy drive: replacement latch frame and rear shaft bushing

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Replacement for the inner latch mechanism and rear shaft bushing on Panasonic 5.25" Floppy Drives.

Ocena
0 / 5
Polubienia
0
Pobrania
0
Wydruki
0
Wyświetlenia
18
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Computers
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Panasonic / Matsushita JU-475 5.25" floppy drive: replacement latch frame and rear shaft bushing (from a JU-475-4)

Replacements for two plastic parts that break when these drives are dropped or knocked on the lever.

- Clamp Bearing A (service manual ref 38, YTF4F03435B2): the white frame that carries the latch shaft, the disk-present lock flap and its spring.

- Clamp Bearing B (ref 37, YTF4F03424B4): the flanged rear shaft bushing.

Both are modeled from flatbed scans and caliper measurements of a broken original and test-fitted in a working drive. The OpenSCAD sources are included.

PRINT

PETG (not PLA, because it creeps under the spring load), 0.15 mm layers, 4 perimeters, no supports. Print the frame chassis-face down and the bushing flange down.

FIT NOTES

On my printer small holes come out about 0.3 mm undersize, and the defaults already allow for that. If the shaft is tight, ream the bores with a 4 mm bit (the bushing bore is blind, so stop before the closed end). If the lock flap doesn't swing freely on its axle, raise axle_clear. Open the .scad files in OpenSCAD to change any fit value in the Customizer.

ASSEMBLY

- The shaft's cross pins pass through the keyway slots with the long side of the pin pointing down-right, seen from the front of the drive.

- The two E-clips straddle the rear wall.

- The flap's steel axle snaps into the slots on the underside and is trapped by the chassis once the frame is screwed down.

- The original M3x6 screws are reused.

- The locating pegs are optional, because the shaft and screws position the frame.

REDESIGN

The original cracks along its keyway slot. This version keeps the long part of the slot on the unloaded side and rounds the slot ends.

CAVEAT

Verified on one drive only (a JU-475-4). Panasonic made several JU-475 revisions, and the frame varies between them. Compare against your part before printing.

The service manual (exploded view and part numbers) is not included here. Search for "Panasonic JU-475-4 service manual".

Tagi