ELECROW ESP32 E-Ink Display Calendar Frame + Stand
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Two-piece printable frame and desk stand for an ELECROW ESP32 E-Ink Display calendar or information dashboard.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 4
- Wydruki
- 0
- Wyświetlenia
- 40
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A two-piece, 3D-printable frame and rear stand for turning an ELECROW ESP32 E-Ink Display into a clean desk calendar or information dashboard.
Compatibility
Designed from the ELECROW ESP32 E-Ink Display Frame v2 Fusion model. This is intended for the specific ELECROW ESP32 E-Ink Display used in the project photos. Before printing, verify your display revision’s outside dimensions, mounting-hole positions, connector clearance, and cable routing.
What it does
The front frame presents the display cleanly on a desk, while the separate rear stand supports it at an easy viewing angle. It works well for a calendar, task list, weather display, home-status screen, or generic EV-information dashboard. Any text, email addresses, appointments, and EV values shown in the photos are fictional demo data.
Included files
STL — print-ready mesh containing the frame and stand
3MF — slicer-ready project
F3D — editable Fusion source
Print settings
Material: PLA is suitable for indoor desk use. PETG is a good alternative where added heat resistance is useful.
Layer height: 0.20 mm
Walls: 3 perimeters
Infill: 15–25%
Supports: Start without supports; add them only if your slicer identifies an overhang on the stand.
Print the frame with its largest flat rear face on the build plate. Print the stand with its broad flat face on the build plate.
Assembly
Test-fit the display in the frame before final assembly.
Confirm all ports, buttons, and cable exits remain accessible.
Attach the stand and place the finished display on a stable, level surface.
Do not force the display into the frame. If fit is tight, adjust clearance in the model or slicer.
License and safety
This model is shared under CC BY-NC-SA 4.0. Commercial use—including selling prints or derivatives—requires permission from the creator. Print, assemble, and use at your own risk. This is a low-voltage desk accessory, not an electrical enclosure; do not use it in a way that compromises electrical safety.