Simple Phone stand (tripod compatible)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Simple 3D-printed phone holder with standard 1/4-20 UNC thread that fits most tripods.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 8
- Wydruki
- 0
- Wyświetlenia
- 47
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Photo & Video
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Description
This is a simple 3D-printable phone holder with a standard 1/4-20 UNC thread that fits most tripods.
The phone holder can be used as a phone mount for a Tripod to take prictures/videos.
Alternatively it can be used with a small tripod for phone calls or for watching videos.
Parts
1x Bottom_bracket
1x Top_bracket
2x Connecting_rod
1x Adjustment_screw_short
1x Adjustment_screw_long
2x Rubber_protector
1x Rotating_connector
1x Stand_bottom
1x Stand_top
1x Stand_protector
Additional Hardware:
1 Rubber band
Tripod with 1/4-20 UNC thread
Assembly
Slide the rubber protectors onto the top and bottom brackets.
Slide the stand protector onto the bottom stand.
Press the two connecting rods into the top bracket and slide the rods into the holes on the bottom bracket.
Hook the rubber band into the hooks on the back of the top and bottom bracket (double up the rubber band if needed).
Screw the rotating connector onto the back of the bottom bracket.
Connect the top part of the stand to the bottom one with the long adjustment screw.
Connect the Bracket assembly to the stand assembly with the short adjustment screw
Usage
To adjust the rotation of the holder, unscrew the back screw a little bit and rotate the bracket. Then tighten the screw.
To adjust the angle of the stand, unscrew the screw on the side a little and tilt the stand. Then tighten the screw.