PVC pipe cap for extended handlebars 04005 NO SUPPORTS

Why does this work??

Because of how the tightly wrapped tape aligns the pipe and perfectly and the grips compress the tape, your new bars are solid as a rock!

How to make custom extended handlebars.

I wanted to get extended handlebars for my mountain bike, the only problem was that it was extremely expensive to get an actual new bar. So i found an old rubber scooter grip and found it could fit on my bike. From there it was a lot of trial and error until i mad my own customer PVC pipe handlebar extenders that was extremely durable. 

Tools and parts needed 

• An extended rubber grip for a mountain bike (I found mine off of a scooter)

• A 04005 PVC pipe (Dimensions can be found in a google search)

• Electrical tape or duct tape (I used electrical)

• PVC pipe cutters 

• A pencil or pen

• 2 of the 3d printed caps

• *Possibly some all purpose oil for sliding the longer grips on

Instructions

1. Take your old handlebar grips off of the bar 

2. Slide your new grips onto the bar and measure how much extra space there is between the original bar and the edge of the grip by pushing your pvc pipe into the grips and marking it.

3. Take the marked end of the pipe and cut it as straight as you can along the line with the cutters

4.  Use the cut piece of the pipe to measure another line and cut another piece 

5. Use your tape to align the bar and the pipe pieces and tape around the outside of them until the the tape is all even (You don't need to worry too much about aligning as the tape will make the pieces straight.

6. Put oil on the inside of the new grips and slide them on to both bars

7. take the caps and insert them into the tube using oil if needed