Slim NVMe Case - Pocket Friendly, Durable & Zero Waste - All Models 2230 - 2242 - 2260 - 2280
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Ultracompact 2piece NVMe SSD enclosure featuring a slide-lock snap clip. Minimal filament use, pocket-safe rounded edge.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 5
- Wydruki
- 0
- Wyświetlenia
- 28
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Hi everyone,
I’ve tried countless NVMe cases, but none quite hit the mark, either they wasted too much filament or the latching mechanism was underwhelming or annoyng.
So here is my take: a slide-lock case featuring a secure snap-clip mechanism. It consists of two separate parts that can easily be replaced individually if worn out over time. While it prints fine in PLA, the clip tab may lose its springiness over repeated use, which is why PETG is strongly recommended.
Designed with portability in mind, its rounded corners and smooth chamfers make it pocket-friendly without wearing out your seams.
Here you can find a connector protective cap for NVMe, M.2, or older SATA models
Recommended Print Settings
Layer Height: 0.20 mm
Walls / Perimeters: 3 walls (or 5 walls for maximum durability)
Infill: 10%
Supports: None needed
PETG Recommended but also work good with PLA
Enjoy and happy printing! If you like this model, please leave a like and a comment with your makes.
Liked my model? Buy me a coffee or a beer to fuel my late night work on the next one!
