Case for M5Stack Add-on Display In/Out - fits Unit PoE-P4
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A case for M5Stack's HDMI input add-on, which ships as a bare board. Made to match the Unit PoE-P4 housing.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 14
- Wydruki
- 0
- Wyświetlenia
- 99
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
M5Stack sells the Add-on Display In (LT6911D) as a bare board with no case. This is a case for it, made to match the Unit PoE-P4 housing: same width, same corners, and the two sit together as one block.
I made it for ESP-KVM, an open-source IP-KVM that runs on the Unit PoE-P4 with this add-on: the target computer's screen, keyboard and mouse in a browser tab, over PoE Ethernet. But the case does not depend on the software - it fits the board whatever runs on it.
openings for the HDMI input on one end and the USB-A port on the other
vent slots on top
Ethernet, USB-C and the side ports of the Unit PoE-P4 stay free
one part, no screws: four tabs clip into the slots of the Unit PoE-P4 housing
the tabs are thin: press the case on gently, and do not pry it off by them
Hardware:
M5Stack Add-on Display In for PoE-P4 (LT6911D): https://shop.m5stack.com/products/add-on-display-in-for-poe-p4-lt6911d
M5Stack Unit PoE-P4
ESP-KVM: