CraftRig - Squared Chamfered 7° Cradle with Dual Magnetic TPU Air Wrist Pads (Logitech Craft)

CraftRig | Chamfered 7° Cradle for Logitech Craft

Designed a clean, geometric 7° cradle for the Logitech Craft. This one goes for a sleek, blocky look with sharp chamfers keeping full access to the top crown dial.

It uses a 2-piece split wrist rest (Left / Right) meant to be printed in TPU Air (or soft TPU with low gyroid infill) for a springy, cushioned feel. The pads snap straight onto the frame using embedded 20x5x2mm magnets.

   Specs & Features

• Angles: Fixed 7° incline for better typing ergonomics.

• Style: Squared-off chassis with deep chamfers and clean edges.

• Wrist Rest: Split L/R pads with air-cushioned TPU support.

• Magnetic Mount: Uses 8x 20x5x2mm neodymium magnets (2 for each pad / 4 base side) to snap into place.

   What You Need

• 8x 20x5x2mm Rectangular Neodymium Magnets

• A drop of superglue or epoxy to secure the magnets in their pockets.

⚠ Disclaimer

Please Note: This model was designed using accurate 3D dimensional reference data from the Logitech 3d files to fit the Logitech Craft keyboard. However, I do not personally own this keyboard model, so I have not physically test-printed this design myself.

While the 3D model shows a proper fit in CAD, tolerances can vary based on your 3D printer's calibration, print settings, magnet manufacturing tolerances, and filament choice. If you print this, please share your feedback, photos, or tolerance notes in the Makes & Comments section so I can refine the design if necessary!

Enjoy!!