Mac mini & Mac Studio Stacking Spacer – Locking, Airflow-Friendly, No Supports
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A locking spacer that stacks Mac minis (2014, 2018, M1) on each other or on a Mac Studio, keeps the bottom intake breath
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 8
- Wydruki
- 0
- Wyświetlenia
- 38
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution
Stack Mac minis (Intel/M1) on top of a Mac Studio, or on top of each other, without blocking the air intake/ports and without anything sliding around.
How it works
- A 4 mm lower lip drops over the top edge of the machine below. A 5 mm upper lip holds the base of the machine above. Neither machine can slide in any direction.
- The upper machine rests on four corner seats. Its foot hangs in a 14 mm air gap, leaving 8 mm under the foot for air to reach the bottom intake.
- The rear stays clear of the exhaust vents and ports: the lip at the back is only 4 mm deep.
- The corners follow Apple's continuous-curvature (squircle) corner shape, not a simple radius, so the lips fit snugly all the way round.
Compatibility (Tested)
- Mac mini 2014, 2018 and M1 (2020): 197 × 197 mm unibody.
- Mac Studio M2 (bottom of the stack only).
- Not for the 2024 and later small Mac mini (M2, etc).
Put the Mac Studio at the bottom: it's the heaviest, and its intake should sit on the desk. You need one spacer per mini.
Two versions
spacer-open.stl: Open between the corners: best airflow, lightestspacer-lattice.stl: 45° lattice side walls: stiffer, more finished look