Sewing Package for Skadis Pegboard

A small collection of various holders for my wife's sewing supplies and tools. :)

• Container:
  8.8 x 8.8 x 9.6 cm
  8.8 x 8.8 x 6.0 cm (small)
  8.8 x 8.8 x 3.0 cm (extra small)
  To allow for quick removal of the container upwards (and for easy printing), it hangs in a holder that must be printed separately.
  The container is available in 3 different sizes (only the height varies in each case, so that one holder size fits all).
  In addition, you can optionally add 2 different subdivisions separately.

• DoubleHook:
  Double hook (staggered, e.g. for two pairs of scissors, each up to 1.5 cm thick).

• DoubleSpoolHolder:
  Double thread spool holder (4 mm diameter) for thread spools (up to 1,000 m each) and space for one additional bobbin each.

• MagnetHolder:
  8x3 mm
  10x2 mm
  10x3 mm
  15x3 mm
  A simple little holder for a round (neodymium) magnet that slides in from the top after printing. There are versions available for different magnet sizes, but only the one with a 10-mm diameter and 3-mm thickness was tested.

• NeedlesetHolder:
  A holder with four rows (9 cm wide, each spaced 5 mm apart for easier handling) for multiple needle sets of various standard sizes (at least in Germany).

• NotepadHolder:
  A holder with a 10 x 5 cm space for notepads or sticky notes.
  To avoid excessive bridging, this is not printed upside down—but as a consequence, the integrated pegboard holders have little contact with the print bed, which is why I recommend using a brim.

• OverlockSpoolHolder:
  Single thread spool holder for big overlock thread spools up to 5,000 m.

• SingleHook:
  Single hook (2 cm hook opening facing forward, 1.5 cm high). With a spring clip (PETG recommended).

• SingleHookFlat:
  A flat version of the single hook (2.2 cm hook opening facing forward, 0.5 cm in height, e.g. for rotary cutters that have only a small hole for hanging). With a spring clip (PETG recommended).

• Storage:
  25 x 8.4 x 2.7 cm
  Up to 11 StorageDivider (print separately) can be inserted, spaced 2 cm apart.
  For easy printing, the mounting brackets are printed separately. They can be attached anywhere on the shelf (2x StorageHolder are recommended).

• VarioPliersHolder:
  You can clamp the “Prym Vario Pliers” into the holder either from the top or from the bottom.
  This holder requires support for the top two hooks.

• VarioToolHolder:
  You can slide the “Prym Vario Creative Tool” onto this holder from the top.
  This holder requires support for the top two hooks.

Most of it was printed with PLA; the only exception are the hooks for a single pegboard hole, which were printed with PETG to prevent the spring lock from breaking.

• My Printing Settings:
  0.2 mm Layer Height
  0.5 mm Layer Width (0.4 mm Nozzle)
  3 Perimeters
  4 Top & Bottom Solid Layers
  15 % Infill
  Support only needed for VarioPliersHolder & VarioToolHolder