1 / 7
Dell Wyse 3040 Flat Mount Bracket — zdjęcie 1
1 / 7

Dell Wyse 3040 Flat Mount Bracket

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Low-profile bracket that bolts to the Wyse 3040’s removable base plate using its four existing holes. Wide and narrow ve

Ocena
0 / 5
Polubienia
0
Pobrania
1
Wydruki
0
Wyświetlenia
34
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Other Ideas
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

A flat mounting bracket for the Dell Wyse 3040 thin client. It attaches to the removable base plate and uses the plate’s four existing holes, so you don’t need to drill or modify anything.

Two versions included

  • Wide bracket: Its mounting points sit outside the Wyse’s footprint, so you can screw it to a wall, desk underside, rack shelf or enclosure after the Wyse is attached. This is the recommended version.

  • Narrow bracket: It stays within the footprint and is meant for cases where the Wyse just rests on or slides onto the bracket. This works, but it can be fiddly.

How it works

  • Heat-set inserts go into the bracket. The base plate is screwed onto the bracket from the inside of the Wyse.

  • The raised cylindrical bosses on the bracket fit exactly into the holes of the base plate. This gives a positive form fit, so the screws only clamp and don’t carry the load.

  • The base plate holes are oversized, so the printed M3 washers are mandatory.

Hardware needed

  • 4× M3 heat-set inserts

  • 4× M3 screws (choose the length to suit your insert depth)

  • 4× printed washers (included)

  • Screws or fasteners to attach the bracket to your mounting surface

Assembly

  1. Remove the base plate from the Wyse 3040.

  2. Press the heat-set inserts into the bracket.

  3. Place the base plate onto the bracket so the bosses sit in its holes.

  4. Fit the printed washers from the inside and screw the plate down.

  5. Reattach the base plate to the Wyse and mount the bracket.

Print settings (suggested)

  • Material: PETG or ASA recommended, because the Wyse gets warm. PLA is fine for cool locations.

  • Layer height: 0.2 mm

  • Walls: 3–4 perimeters, so the inserts have enough material around them

  • Infill: 30–40 %

  • Supports: none required

Tagi