1 / 4
Xbox Series X Vent Deflector – Open Flow (no hole grid) air Duct — zdjęcie 1
1 / 4

Xbox Series X Vent Deflector – Open Flow (no hole grid) air Duct

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

I needen a Air Duct for my Xbox that the heat dont stays in the Shelf, i took the design from Gavin-R and gave it Claude

Ocena
0 / 5
Polubienia
3
Pobrania
15
Wydruki
0
Wyświetlenia
31
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Video Games
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Remix of “Xbox Series X Side Vent Deflector” by JellyBird97 (MakerWorld): [Xbox Air Vent]
Licensed under CC BY-NC-SA 4.0. '
Changes: removed the hole grid, added guide fins, open inlet cut-outs, new Slim version.

Two versions:

  • Open Flow: 66 mm tall, maximum outlet area (145 × 64 mm)

  • Slim: 46 mm tall, about 30 % less height, so it sticks out less from the console side. Good for very tight shelves.

    Print settings:

  • Orientation: outlet face down on the bed

  • Material: PETG recommended (warm exhaust air)

  • 0.2 mm layers, 3 walls, 10–15 % infill

  • Supports:  needed

Fit / post-processing:
The pegs fit into the Xbox top vent. You may need to lightly sand them where the support touched and at the seam, so they slide in smoothly.

Bed slinger printers (moving bed, e.g. Prusa MK3/MK4, Bambu A1, Ender 3):
The part stands tall and narrow on the bed, so it can tip over from the bed movement. Rotate it so the long 150 mm side runs parallel to the bed’s direction of movement (front to back, Y axis). Then the bed pushes along the stable long side and not against the narrow side. A brim (5–8 mm) is also recommended for extra bed adhesion.


printed with anycubic Kobra v3



Tagi