1 / 14
Hakki Pilke 2x Oil Cap / Öljy Korkki — zdjęcie 1
1 / 14

Hakki Pilke 2x Oil Cap / Öljy Korkki

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Replacement chain oil cap for firewood processor Hakki Pilke 2x. Öljy korkki klapikoneeseen.

Ocena
0 / 5
Polubienia
0
Pobrania
0
Wydruki
0
Wyświetlenia
18
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — NoDerivatives

Replacement chain oil tank cap for firewood processor


A 3D-printable replacement chain oil tank cap designed for the firewood processor.
Features & Specifications:
-O-ring: Designed to fit a 41x5 mm O-ring at the base for a proper seal.
-Breather hole: Features a standard M8 thread through the center. You can insert a standard M8 bolt to act as an adjustable/closable breather vent while operating the machine.
-Recommended materials: PETG, ABS, or Nylon (for chemical resistance against oil). Avoid regular PLA.
-Print settings: It is recommended to use 3-4 perimeters and around 20 percent infill.
Post-processing: If the M8 thread feels too tight after printing, you can clean it up and open it for the bolt using a standard hand tap.

If you do this, please share a photo with me.

Hakki Pilke 2x teräketjuöljysäiliön korkki


3D-tulostettava varakorkki Hakki Pilke 2x -klapikoneen teräketjuöljysäiliöön.
Ominaisuudet ja tekniset tiedot:
-O-rengas: Korkin tyveen sopii 41x5 mm kokoinen O-rengas tiivistystä varten.
-Ilmareikä: Korkin läpi menee standardi M8-kierre. Siihen voi kiertää M8-pultin, joka toimii ilmarakona/venttiilinä klapikonetta käytettäessä.
-Materiaalisuositus: PETG, ABS tai Nylon.
Tulostusasetukset: 3-4 seinämää ja täyttöaste 20 prosentin luokkaa.
Jos M8-kierre on tiukka korkin päällä, niin normaalilla kierretapilla saa sitä avattua pultille sopivaksi.

Tagi