Drill Accessory Holder for Skadis – Bits, Brushes, Core Bits – M3 T-Nut
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Two-part Skadis holder for drill accessories: 6 drill bits, step drill, core bits, cup and wheel brushes. M3 T-nut mount
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 1
- Wydruki
- 0
- Wyświetlenia
- 14
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Garage
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Skadis storage for a typical set of drill accessories, for a normally mounted IKEA Skadis board (vertical slots). Two independent parts.
PART 1 – SHELF (166 × 68 × 54 mm), two tiers
- Front: 6 drill bits, shank down, size embossed on the front: 3, 5, 6, 8, 10 mm (round shanks) and 12 mm SDS-plus. Holes: 3.5 / 5.6 / 6.6 / 8.6 / 10.7 / 10.7 mm.
- Back (6 mm higher), from left: step drill (10 mm shank), small tile core bit (8 mm shank), end brush and cup brush (6 mm shanks), SDS-plus core bit (30 mm deep hole).
PART 2 – WHEEL BRUSH HANGER (124 × 28 × 40 mm)
- Two wheel brushes on 6 mm shanks hang flat against the board, so they don't need a deep shelf.
- The holes slope 8° down into the part, so the brushes don't slide out.
- 104 mm between the holes – enough for brushes up to about Ø75 and Ø85 mm. The brushes stick out about 30 mm past the sides.
The layout matches my own set. Check your shank sizes against the hole list above before printing.
MOUNTING
- Hardware: 2× printed M3 T-nut + 2× M3x16 socket head screw per part (4 of each in total).
- Shelf: screws in the back plate above the back tier, 120 mm apart. Hanger: screws 40 mm apart, heads recessed in the plate between the posts.
- Mount the empty parts first, then load them – the accessories cover the screw heads.
- If you hang the parts side by side, keep their centres at least 200 mm apart (the core bit and the brushes stick out past the parts).
PRINTING
- Both parts standing, as in the files. No supports.
- Shelf: 0.2 mm, 2 perimeters, Lightning infill 10% (about 67 g).
- Hanger: 4 perimeters, 20% gyroid (about 43 g) – the brushes lever on the horizontal holes, so the walls need to be stronger.
- Both settings are saved per part in the 3MF project (both parts fit on one plate).
T-nuts: printed M3 T-nut by ORM (https://www.printables.com/model/450444) – 0.12 mm layers, 100% infill. Alignment guide dimensions follow 6d6178's Skadis T-Nuts Mounting System (https://www.printables.com/model/228663).