Screw-down cable tie mount 30 mm - countersunk M4, double tunnel
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Compact 30 x 30 mm cable tie base with a countersunk M4 screw hole and two tie tunnels. Flat bottom, no supports.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 1
- Wydruki
- 0
- Wyświetlenia
- 10
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Share Alike
A small, sturdy base for fixing cables with a zip tie. Screw it to a wall, the underside of a desk, a cabinet or a machine frame, run a cable tie through the two tunnels and pull tight. The adhesive-backed ones from the hardware store always let go after a while; this one is screwed down and stays put.
DESIGN
30 x 30 mm, 5 mm thick plate with rounded corners and a small chamfer on the top edge. Flat underside for a clean fit against the surface.
Countersunk hole for M4 (4.5 mm through, 90 degree countersink, 8.8 mm) in the centre. The screw head sits flush with the top, so the cable never touches it. A 4 mm wood screw or an M4 bolt both work.
Two tie tunnels, one on each side of the screw, 12 mm wide and 4.4 mm high. The slot takes cable ties up to 4.8 mm wide (the usual 3.6 and 4.8 mm sizes). The tie runs through both tunnels, so the cable sits over the screw head in the middle and is clamped from two sides. Or use two cable ties next to each other.
The top edges of the tunnels are rounded (1.2 mm) so the tie bends without cutting into the plastic.
PRINTING
Print as oriented, flat side down. No supports: the tunnel bridges are 5.5 mm and print cleanly.
PLA or PETG, 0.20 mm layers, 3 perimeters, 20% infill. The part is mostly perimeters anyway.
About 6 g and 7 minutes per piece on a Prusa CORE One (0.4 nozzle). The included project prints two at a time in 15 minutes.
For outdoor use or near heat, PETG or ASA.
FILES
cable-tie-mount-30mm.stl / .step: the mount
cable-tie-mount-30mm-2x_PLA_CoreOne.3mf: PrusaSlicer project, two pieces
cable-tie-mount-30mm-2x_0.2mm_PLA_COREONE.bgcode: ready to print on a CORE One, 0.4 nozzle, PLA