TP-Link LS108G Switch End Caps - Underware / Multiconnect (hex)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Two hex end caps that hold a TP-Link LS108G 8-port switch under the desk on Multiboard with Multiconnect.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 0
- Wydruki
- 0
- Wyświetlenia
- 6
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Two identical caps that hold a TP-Link LiteWave LS108G under the desk on a Multiboard. I measured mine at 158 x 100 x 26 mm.
The first RJ45 port starts 25 mm from the end, so the side walls are only 15 mm deep and all the ports and the power jack stay free. The part under the switch is longer, 50 mm, so it has more to sit on.
Each cap takes one Multiconnect connector, and the connectors go 125 mm apart (5 holes).
My first print had the slot 3.5 mm further in, which put the connectors 117 mm apart, and that spacing doesn't exist on a 25 mm grid. This version fixes it. If you printed the old one it still works: mount it at 125 mm and stick a 4 mm rubber pad at each end to take up the slack.
Print settings
PLA or PETG, 0.2 mm layers, 3 walls, 15% infill, no supports. Print two. The STL is already standing on the closed end, the way it prints without supports.
The slot follows the Multiconnect v2 standard by Hands on Katie (QuackWorks)