Slide-in case for C64 Pi1541-III
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A slide-in case for the C64 Pi1541-III project.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 1
- Wydruki
- 0
- Wyświetlenia
- 10
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Share Alike
This is a simple two-part case for tebl’s C64 Pi1541-III board and its display panel
https://github.com/tebl/C64-Pi1541-III
The board slides in on rails and the front plate locks everything in place. Both parts print without supports.
Features
Slide-in design: the board sits on printed rails
Front plate with cutouts for the OLED, tactile switches, and the rotary encoder.
Two spacers with locating studs rest on the display panel and hold the plate at the right distance.
Two stems on the plate take M3 screws, so you can fix the panel to the plate before sliding it into the case.
Cutouts for the two IEC DIN sockets, the 5V DC jack and the Pi’s microSD slot, plus vent slots in the top.
Engraved labels: “5V” and “IEC” on the back, “Pi1541 III”, “B” and “I” on the front.
Optional text inlays, so you can print the front lettering in a contrasting colour.
Recesses underneath for rubber feet
Print settings
Shell: print standing on its back wall, with the open front facing up. No supports. The STL is already in this orientation.
Plate: print face-down, with the spacers and stems pointing up. No supports.
Layer height: 0.2 mm
Walls: 3 or more
Infill: 20%
Material: PLA or PETG
Hardware
4 × M3 self-tapping screws. Two go into the plate stems to hold the panel, and two go through the plate into the pilot holes (2.7 mm) in the case bosses.
The pilot holes are sized for self-tapping. If you prefer heat-set inserts, enlarge them to about 4.1 mm