Guition 4848S040 (ESP32-S3 4" Touch Panel) SKÅDIS Mount – Clip-in Back Plate
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
wap the stock plastic back of the Guition 4848S040 for this and hang it on an IKEA SKÅDIS pegboard. Two screws out, clip
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 2
- Wydruki
- 0
- Wyświetlenia
- 33
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Creative Commons — Attribution — Noncommercial
Fitting:
Remove the two small screws holding the stock plastic back plate on, and lift it off. Keep the screws and the old plate in case you want to go back.
Clip this plate on in its place. No screws needed.
Hang it on the SKÅDIS: push the hooks through and drop it down to seat.
Orientation: the panel mounts on its side with the USB-C coming out the bottom. If you’re running EspControl, fix the screen orientation from the panel’s own web page: Screen → Rotation → Apply Configuration. It’ll be 90 or 270 depending on which way you’ve turned it; if everything comes up upside down, use the other one. No reflash needed.
Hooks: three hooks in a triangle on the standard SKÅDIS grid: two on the bottom row 40 mm apart, one on the row above, 20 mm up and centred between them. They’ve been slimmed down after the first test print was too tight in the slots, so they should push through without a fight. If your board is on the tight side of tolerance, let me know.