1 / 9
Magnetic Cable Clip for LINAK Desk Frame 2 — zdjęcie 1
1 / 9

Magnetic Cable Clip for LINAK Desk Frame 2

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Flat magnetic cable clip for the steel foot of a LINAK Desk Frame 2. Two Ø10×2 mm magnets, no screws, no supports.

Ocena
0 / 5
Polubienia
2
Pobrania
3
Wydruki
0
Wyświetlenia
7
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Office
Licencja
Creative Commons — Attribution

🇩🇪 Deutsche Beschreibung weiter unten.

Flat cable clip for the steel foot of a LINAK Desk Frame 2. Held by two magnets – no screws, no drilling. Fits 1–2 power cables (Ø7.5 mm) and 1–3 network cables (Ø4 mm), the cables slide freely.

You need: 2× neodymium magnet Ø10×2 mm, a drop of super glue.

Print: PETG, as provided (already oriented), no supports. Print the test slice first to check the fit.

Assembly: Press the magnets in from below, secure with glue, place the clip over the cables.

The FreeCAD file is parametric (length, channel size, magnet size, clearance).

Not affiliated with LINAK A/S.

---

🇩🇪 Deutsch

Flache Kabelklammer für den Stahlfuß eines LINAK Desk Frame 2. Hält mit zwei Magneten – ohne Schrauben, ohne Bohren. Passt für 1–2 Kaltgerätekabel (Ø7,5 mm) und 1–3 Netzwerkkabel (Ø4 mm), die Kabel gleiten frei.

Benötigt: 2× Neodym-Magnet Ø10×2 mm, ein Tropfen Sekundenkleber.

Druck: PETG, so wie geliefert (bereits ausgerichtet), ohne Support. Zuerst das Testslice drucken und die Passung prüfen.

Montage: Magnete von unten eindrücken, mit Kleber sichern, Klammer über die Kabel setzen.

Die FreeCAD-Datei ist parametrisch (Länge, Kanalgröße, Magnetgröße, Spiel).

Kein offizielles Zubehör von LINAK A/S.

Tagi